Mettler Toledo IND500x Installationsanleitung Seite 6

Disposal of Electrical and Electronic Equipment
In conformance with the European Directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE) this device may not be disposed of in domestic waste. This also applies
to countries outside the EU, per their specific requirements.
Please dispose of this product in accordance with local regulations at the collecting point
specified for electrical and electronic equipment. If you have any questions, please contact
the responsible authority or the distributor from which you purchased this device. Should this
device be passed on to other parties, the content of this regulation must also be related.
6
WARNING
Only the components specified in the user manual can be used in this device.
All equipment must be installed in accordance with the installation instructions
detailed in the user manual. Incorrect or substitute components and/or
deviation from these instructions can impair the instrinsic safety of the
equipment and could result in bodily injury and/or property damage.
WARNING
To prevent ignition of hazardous atmospheres, disconnect the equipment from
its power source before opening the enclosure. Keep cover tightly closed while
the circuit is energized. Do not open when an explosive dust atmosphere is
present.
WARNING
Before connecting/disconnecting any internal electronic components or inter-
connecting wiring between electronic equipment always remove power and wait
at least thirty (30) seconds before any connections or disconnections are made.
Failure to observe these precautions could result in damage to or destruction of
the equipment and/or bodily harm.
WARNING
The explosion-protected weighing system must be checked to ensure
compliance with the requirements for safety before being put into service for
the first time, following any service work and every 3 years, at least.
WARNING
Observe precautions for handling electrostatic sensitive devices.
IND500x