See also
Power Connection Page 22
1.10 Manufacturing Date
The manufacturing date or the date code for the terminal can be found on the serial data plate (on top of the
enclosure). See also Chapter 7.1.10 [Marking Plate Example Page 56].
1.11 Compliance Information
National approval documents, e.g., the FCC Supplier Declaration of Conformity, are available online and/or
included in the packaging.
www.mt.com/ComplianceSearch
IND500x
WARNING
(1)
X1 is covered with a protective tape before shipping. If X1 is used for power
supply or scale interface, remove the protective tape and use the ATEX/IECEx
cable gland. If X1 is left not used, remove the protective tape and block it with
an ATEX/IECEx Dummy Stopper. Refer to [Harsh Enclosure Cable Glands
Page 19] and [Power Connection Page 22] for more information.
Important Safety Message
The cable diameters do not correspond to the enclosure openings, but to the
cables used. The cable diameter and the cable gland used must fit.
WARNING
The IP65 protection must always be maintained. Both the Installation Personnel
and customers should not do not do anything that could damage the terminal.
Introduction
13