Error Log; Communications - Mettler Toledo IND500x Installationsanleitung

Event Code Event Description
23 Calibration test passed.
28 Successful zero command
55 Step calibration performed.
56 1-Point Test failed.
57 1-Point Test expired.
58 1-Point Test passed.
59 Walk Test failed.
60 Walk Test expired.
61 Walk Test passed.
62 Custom Named Event Test failed.
63 Custom Named Event Test expired.
64 Custom Named Event Test passed.
Event ID 15, 16, 17 are added manually. Other Events are added automatically when the Events are triggered
by Operation described in Event Description.
Table File Transfer
The file to hold all Maintenance Log Records: ram:\\maint.log
The file for customer to view: gen:\\maint.csv

3.4.6.3 Error Log

Error Log contains the happened events or alarms, and customers or technicians can use this log to trace the
operations / events / alarms.
Configuration
Because alarm importance varies from customer to customer, it is imperative that the customer has a choice of
which alarms that they would like to see / receive. The reason to "turn off" lower priority alarms is to reduce so
called "alarm floods" where too many alarms are reported.
Below is a sample of the setup table of a typical device for alarming. Level 5 alarms would always be reported
and cannot be disabled due to security and liability issues. The customer always has the option to ignore
alarms at their own risk.
NAMUR Level Log
5
4
3
2
1
Log File Size
The log file can hold a maximum of 500 records. The used size will be checked while new error is recorded. If
the used size is more than 75%, 90% or full, hint information will be thrown to inform user to do backup and
clear error log.

3.5 Communications

This section is intended as a reference concerning only the structure and setup of communication protocols
supported by the IND500x terminal.
IND500x
Description
Yes (fixed) -
Yes/No
Customer could decide whether the level should be recorded.
Yes/No
Yes/No
NA -
NOTICE
Incorrect wiring of the communication circuits
The IND500x terminal or interface board become damaged.
Wire the communication circuits exactly as shown in the Chapter Installation.
Status (String)
SUCCESS
SUCCESS
SUCCESS, FAILURE
1-n = failed at step n
"1"= Days
SUCCESS
1-n = failed at step n
"1" = Days
SUCCESS
1-n = failed at step n
"1" = Days
SUCCESS
Appendix​ ​ 85