Mettler Toledo IND500x Installationsanleitung Seite 24

6 Carefully rotate the front cover 180 degrees and reattached the two grounding straps to the two studs on the
opposite side of the housing shown in the figure below, near the grip bushings using the two nuts removed
in the previous step. Tighten the two nuts.
7 Mark the position of the mounting holes on the vertical surface per the dimensions shown in the figure
below or by holding the terminal up to the surface and marking through the bracket holes. Dimensions are
provided in [mm].
8 The hardware to mount the terminal to the vertical surface is not included with the terminal – it must be
supplied locally. Ensure that the mounting hardware is capable of supporting the weight of the terminal,
which is approximately 4 kg (8.8 lb). Using the locally supplied hardware, mount the terminal to the
vertical surface.
See also
Opening the Enclosure Page 14
16 Installation​ ​
Rear Housing
Stud
Grounding strap
Front cover
IND500x