Connecting Diagram Flow Control En - Abicor Binzel CR1000 Betriebsanleitung

CR1000/CR1250
Pos. Item description
8 Housing
9 On/off switch
10 Fuse (3 fuses for version with 400 V)
11 Rubber foot (x 6)
12 Cooling water plug-in connector, NW 5, red
13 Cooling water plug-in connector, NW 5, blue
14 Connection plug for flow control
15 Motor support
16 Support for coolant container
17 Coolant container bracket (x 2)
18 Coolant container
19 Outlet neck screw cap
20 Filler neck screw cap
Tab. 11 CR1250 spare parts
13.3 Connecting diagram flow control
NOTICE
• This connection option is only suitable for 2-cycle mode.
• The cooling unit disconnects the welding current if the coolant level is low and the torch trigger is pressed.
• The flow control is preset to 0.6 – 0.8 l/min.
Welding power source
Torch control switch
at welding power source
Fig. 12 Connecting diagram flow control
BAL.0351.0 • 2018-08-15
Torch trigger
Connection housing
Flow control connector
at front of cooling unit
Flow control
(low cooling liquid volume opens
switch)
13 Appendix
EN - 21