Assembly - Hecht 8514 Originalbetriebsanleitung

• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
EN
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
• If you notice transport damage or while unpacking, notify your supplier immediately. Do not
operate the product!
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
DE
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
C Fasteners can become loose during transport in the packaging.
PACKAGE CONTENTS
CS
1x body of the machine, 1x basic suction tube, 1x end suction tube, 1x straight blow tube, 1x
end blower tube with nozzle, 1x collection bag, 1x connecting knee bag, 1x manual for use
• Standard accessories are subject to change without notice.
• This product requires assembly. The product must be assembled correctly before use.
SK

ASSEMBLY

• Z-Hook of the Cable Shall be pulled through the hole in the Lever (fig. 2
• Both ends of the Lever shall be put into the holes by left end and right end of the handle (fig. 3
• The Cable is on the bottom of the lever (fig. 4
Rear wheels drive Lever Assembly (fig. 4)
PL
• The Lever shall be assembled according.
Handle Assemble (fig. 5)
• Each part of handle shall be assembled together and connected with two screws
Collecting bag holder Assembly (fig. 6)
HU
• Both ends of the Holder shall be inserted into Collecting Bag and fit into the corresponding
holes in the upper part of the handle (four holes)
Hose Console Assemble (fig. 7)
• Insert both ends of the hose console to the upper part of the Handle.
Collecting Bag Installing (fig. 8 -11)
• Attach the collecting bag to the construction of the Handle and use buckles for safety
measures.
• Lift the air exhaust flange upwards in the lower part of the machine. (The Flange is secured
by safety buckle. It is important to loosen the safety buckle).
• Install Air Suction flange onto the Shoulders Construction (Sliding from top to bottom).
Rotating Wire Brush/ Rotating Brush Installation (fig. 12 - 17)
• Please choose only one type of brush according to your needs and working
environment, or do not use any type of brush.
24 / 160
HECHT_8514_manual_2019.indd 24
)
a
).
a
).
a
10.06.2019 9:55:52