Operation; To Start Engine; Stopping The Engine; Use Of The Machine - Hecht 8514 Originalbetriebsanleitung

OPERATION

EN
The instructions in this manual apply under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.
DE

TO START ENGINE

• Ignition is connected through the cable and the spark plug cap (the rubber boot) with
the spark plug. Check the connection.
• When starting the cold engine, turn the choke / throttle lever to the "Start" position. When
starting a warm engine, move the lever to the "Maximum speed" position.
• Grasp the starter handle and pull gently on the starter handle until it begins to resist, then
pull quickly and forcefully upwards.
CS
A
CAUTIONG!
Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter.
SK
Rapid retraction of starter cord (kickback) will pull hand and arm toward engine
faster than you can let go. Broken bones, fractures, bruises or sprains could result.
• Return the starter handle slowly to the rope guide bolt after engine starts.
• Operate the engine with the choke / throttle lever in the "Maximum Speed" position.
PL
C Do not lean the machine when starting the engine. Run the engine on a flat surface
where there are no obstructions.

STOPPING THE ENGINE

• Turn the choke / throttle lever to the "Stop" position and wait for the engine to stop.
HU
C If the machine is left unattended for a longer time, secure it against accidental start
by disconnecting and grounding of the spark plug wire.

USE OF THE MACHINE

Rotary rollers are designed to operate under normal conditions on a hard surface. Do not use
them in extreme conditions such as wet and muddy terrain, snow, high grass, wet soil, etc.
Do not use the machine to vacuum soft fibres, cloths, plastic straps, wires and cables,
or higher number of plastic bags. Do not dispose of waste dumps and do not try to
vacuum large pieces of waste.
SUCTION HEIGHT ADJUSTMENT
• Push the suction height adjustment handle from the machine body and move the forward
/ reverse handle to set the desired height. Then lock the lever in the desired position into
the ridge. The lift height is the smallest in the front position of the lever. By sliding into
the back (position), you will reach the highest height.
28 / 160
HECHT_8514_manual_2019.indd 28 10.06.2019 9:55:53