Spark Plug; Carbon Sediments - Hecht 8514 Originalbetriebsanleitung

Replace filter if frayed, torn, damaged or unable to be cleaned.

SPARK PLUG

For best results, replace the spark plug every 100 hours of use. Use only the recommended spark
plug which is the correct heat range for normal engine operating temperatures. To find actual
types of recommended spark plugs please contact an authorized service center.
A
CAUTIONG!
If the engine was in operation before a short time, let it cool down. Be carefull not
to touch this parts.
Incorrect spark plugs can cause engine damage.
For good performance, the spark plug must be properly gapped and free of deposits.
1. Disconnect the cap from the spark plug and remove any dirt from the spark plug area.
2. Use the proper size spark plug wrench to remove the spark plug.
3. Inspect the spark plug. Replace it if damaged, badly fouled, if the sealing washer is in poor
condition, or if the electrode is worn.
4. Measure the electrode gap with a suitable gauge. The correct gap is listed in the Specifications.
If adjustment is needed, correct the gap by carefully bending the side electrode.
5. Install the spark plug carefully, by hand, to avoid cross-threading.
6. After the spark plug is seated, tighten with the proper size spark plug wrench to compress
the washer.
7. When installing a new spark plug, tighten by 1/2 turn after the spark plug seats to compress
the washer.
8. When reinstalling the original spark plug, tighten by 1/8 - 1/4 turn after the spark plug seats
to compress the washer.
9. Attach the spark plug cap to the spark plug.
I
Over tightening the spark plug can damage the threads in the cylinder head.
Note:
MUFFLER
Allow the engine and exhaust to cool before handling.
• Remove accumulated debris from muffler area and cylinder area.
• Make sure the muffler is without cracks, corrosion or other damage.
• If the exhaust system is fitted with a spark arrester, it must be kept clean and passive.
After removing the arrester and knocking out the coarse dirt, clean the arrester with
a fine brush (e.g. toothbrush) from all deposits. After cleaning, reassemble it.

CARBON SEDIMENTS

It is recommended to remove carbon sediments from cylinder, piston upper side and valves
surrounding each 100 – 300 operating hours in authorised service center.
HECHT_8514_manual_2019.indd 33
EN
DE
CS
SK
PL
HU
33 / 160
10.06.2019 9:55:54