Hecht 8514 Originalbetriebsanleitung Seite 29

START BRUSH / WIRE ROTARY ROLLER (BRUSH)
• To start the engine, press the roller rotation handle toward the handle. The roller rotates in
the same direction as the machine is moving.
Starting the drive (moving the machine)
• Run the drive (start moving) only when the engine is started by pressing the drive lever
towards the handle. Before starting the drive, initiate the rotary drum first.
C Do not exceed the speed by pushing the machine.
BUMPER
Even if the bumper protects the suction hole from accidental impact, try to avoid unnecessary bumps.
With normal travel speed (3.4 km / h) when impacting curbs, fixed fixtures, walls, etc. at an angle
of less than 45 °, the bumper will help to change the direction of the travel. If there is an impact
at a larger angle, the bumper loses its function and damages the suction opening.
SUCTION / EXHALATION HOSE WITH TELESCOPIC HANDLE
The hose can be used for both suction and blowing.
A
CAUTIONG!
NEVER INSTALL THE HOSE TO THE MACHINE WHEN THE MACHINE IS TURNED
ONG! The machine must be secured against accidental start-up during installation/
deployment, and all its movable parts cannot be moving.
SUCTION FLAP
• Insert the suction flap as shown in the figure (picture). By doing so, it is possible to increase
the suction performance when using a hose.
C FLAP CAN BE USED ONLY IF THE HOSE IS USED.
SUCTION HOSE
• You can loosen (Release) the Suction Cap by turning it in the front part of the machine. 5046.
• Insert the hose flange into the hole. Rotate it to prevent the flange from falling out.5044
FUKAR (BLOWING)
• Firstly, remove the Collecting Bag and secure the Outlet Flanges.
• You can loosen the release cap by turning it.
• Insert the hose flange into the hole and protect it from falling out by turning it.
• Adjust the telescopic handle to a comfortable length.
COLLECTING BAG:
• Make sure the bag is closed before starting the machine.
B
WARNINGG!
NEVER OPEN, CONNECT, DISCONNECT OR REMOVE THE COLLECTING BAG WHEN THE
MACHINE IS TURNED ON.
HECHT_8514_manual_2019.indd 29
EN
DE
CS
SK
PL
HU
29 / 160
10.06.2019 9:55:54