Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RP-R-4042B2, 4064B2
CHAPTER 9 - MAINTENANCE
Only trained personnel who knows how the lift works, must be allowed to service
the lift.
To service properly the lift, the following has to be carried out:
• use only genuine spare parts as well as equipment suitable for the work required;
• follow the scheduled maintenance and check periods shown in the manual;
• discover the reason for possible failures such as too much noise, overheating, oil blow-by,
etc.
• refer to documents supplied by the manufacture or dealer to carry out maintenance.
Before carrying out any maintenance or repair on the lift, disconnect the power
supply, padlock the general switch and keep the key in a safe place to prevent
unauthorized persons from switching on or operating the lift.
9.1
ORDINARY MAINTENANCE
The lift has to be properly cleaned at least once a month using self-cleaning clothes.
The use of water or inflammable liquid is strictly forbidden.
Be sure the rod of the hydraulic cylinders is always clean and not damaged since this may result in
leakage from seals and, as a consequence, in possible malfunctions.
9.3
PERIODIC MAINTENANCE
Daily pre-
operation
Every 1 month
Every 12 months
REV. 01
RP-TOOLS Werkstatt-Technik
• Check hydraulic connections and hoses for leaks
• Check safety lock audibly and visually while in operation
• Check bolts, nuts and screws are tight
• Check all cable connections, pins and bolts to insure proper mounting
• Check all anchor bolts and retighten if necessary
• Check columns for square-ness and plumb
• Check steel cable tension, adjust if necessary
• Check all lifting pads, replace if necessary
• Lubricate columns with grease
• Lubricate all pivot pins
• Check the hydraulic oil, fill or replace if necessary
• Check hydraulic systems for proper operation
• Verify that all components and mechanisms are not damaged
• Verify the steel cables are not worn up to 5%, change if necessary
• Check the electrical system to verify that the motor, limit switch and
control panel operate properly (this work must be carried out by
skilled electricians)
• empty the oil tank and change the hydraulic oil
87 / 94
Werbung
Inhaltsverzeichnis
