RP-Tools RP-4042B2 Installations- Und Wartungshandbuch Seite 56

RP-R-4042B2, 4064B2
• Line up the runways with the bolt holes in the transverse beams and temperately bolt the screw
M16X50 with the nut M16, washer D.16 and locking washer D.16 in position as shown in the
figure 15B.
• Make sure the cables are routed correctly as shown in the figure 16 and make sure that cables on
the safety rollers.
Before installation, make sure that all accessories have been installed in the
runways and transverse beams.
Fig.15B
(RP-4064B2)
7.7B (RP-4064B2) INSTALLATION OF COLUMNS (ref. fig. 17B)
• Transport the columns to the located site.
• Move each column toward the respective end of the
transverse beam until stopped by the slide block on the
transverse beam. Make sure that all columns are
positioned in the correct location (ref. fig.2). Make sure to
use caution to prevent columns from falling over. If
necessary, use the shims.
• Slide the safety rack down inside each column. Make sure
to slide the rack through the groove of the slide blocks.
• Assemble the nut M20 (1/fig.17) to the adjustment rod
(2/fig.17).
• Insert the rod through top of the column and screw it into
the safety rack.
• Insert the steel cable through top of the column and assemble the locking nut M22 (3/fig.17) and
washer D.22 (4/fig.17).
Each cable must be routed through the column hole toward to the lift center. The
lift cannot work properly and thus damage the cable if failure to do so.
• Adjust each rack in equal height by tightening or unloosing the nuts.
• Adjust each cable in equal tension by tightening or unloosing the nuts.
7.8 ANCHORING COLUMNS
• Before proceeding, check the measurement referring to the layout figure 2 and make sure that
the base plate of each column is square.
REV. 01
RP-TOOLS Werkstatt-Technik
55 / 94
Fig.16 B
(RP-4064B2)
Fig. 17 B
(RP-4064B2)