Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RP-R-4042B2, 4064B2
CHAPTER 6 – SAFETY
Read this chapter carefully and completely because it contains important information for the safety
of the operator and the person in charge of maintenance.
The lift has been designed and built for lifting vehicles and making them
stand above level in a closed area. any other use is forbidden.
The manufacturer is not liable for possible damages to people, vehicles or
objects resulting from an improper or unauthorized use of the lift.
For operator and people safety, a safety area at least 1m free away from the lift must be vacated
during lifting and lowering. The lift must be operated only from the operator's control site in this
safety area.
Operator's presence under the vehicle, during working, is only admitted when the vehicle is lifted
and runways are not running.
Never use the lift when safety devices are off-line. People, the lift and the
vehicles lifted can be seriously damaged if these instructions are not
followed.
6.1
GENERAL WARNINGS
The operator and the person in charge of maintenance must follow accident-prevention laws and
rules in force in the country where the lift is installed
They also must carry out the following:
• neither remove nor disconnect hydraulic, electric or other safety devices;
• carefully follow the safety indications applied on the machine and included in the manual;
• observe the safety area during lifting;
• be sure the motor of the vehicle is off, the gear engaged and the parking brake put on;
• be sure only authorized vehicles are lifted without exceeding the maximum lifting capacity;
• Verify that no one is on the runways during lifting or standing.
Any use of the lift other than that herein specified can cause serious accidents to
people in close proximity of the machine.
6.2
RISKS FOR PEOPLE
All risks the personnel could run, due to an improper use of the lift, are described in this section.
REV. 01
RP-TOOLS Werkstatt-Technik
39 / 94
Werbung
Inhaltsverzeichnis
