RP-Tools RP-4042B2 Installations- Und Wartungshandbuch Seite 44

RP-R-4042B2, 4064B2
6.9 RISKS OF BREAKING COMPONENT DURING OPERATION
Materials and procedures, suitable for the designed parameters of the lift,
have been used by the manufacturer to build a safe and reliable product.
Operate the lift only for the use it has been designed for and follow the
maintenance schedule shown in the chapter "Maintenance".
6.10 RISKS FOR UNAUTHORIZED USES
The presence of unauthorized persons next to the lift and on the platforms is
strictly forbidden during lifting as well as when the vehicle has been already
lifted
6.12 RISKS DURING VEHICLE LIFTING AND WORKING
To avoid overloading and possible breaking during lifting and working, the following safety devices
have been used:
• A maximum pressure valve placed inside the hydraulic unit to prevent excessive weight.
• A parachute valve is built in the cylinder to prevent the lift from a sudden lowering in case of
the hose burst.
The maximum pressure valve has been preset by the manufacturer to a proper
pressure. DO NOT try to adjust it to overrun the rated lifting capacity.
• Automatic mechanical back-up safety holds on the lift in the elevated position.
• Slack safety in event of cable slackening and/or failure.
• Beeper sound can be heard for the final lowering phase to avoid the feet from crushing.
It is strictly forbidden to modify any safety device. Always ensure the safety device
for proper operation during the service.
REV. 01
RP-TOOLS Werkstatt-Technik
43 / 94
Fig. 11
Fig. 12