Warning Message; Error Message - Yamaha RX-V2600 Bedienungsanleitung

TROUBLESHOOTING
After AUTO SETUP

Warning message

W1:Out of Phase
W2:Over24m/80ft
W3:Level Error
W4:SP Mismatch
Notes
• If the ERROR or WARNING screens appears, check the cause of the problem and then perform the AUTO SETUP procedure again.
• If warning W-1 or W-4 appears, corrections are made, but they may not be optimal.
• If warning W-2 or W-3 appears, no corrections are made.
• If error E-10 occurs repeatedly, please contact a qualified YAMAHA service center.
■ HDMI

Error message

Device Over
HDCP Error
120
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the speaker and the
listening position is over 24 m.
The difference of volume level among
speakers is excessive. (No level correction
is made.)
The Wiring results are incompatible with
the current user settings.
Cause
More than 5 HDMI components including
this unit are connected.
HDCP testing failed.
Remedy
Check the speaker connections for proper polarity
(+ or –).
Bring the speaker closer to the listening position.
Readjust the speaker installation so that all speakers
are set in locations with similar conditions.
Check the speaker connections.
Use speakers of similar quality.
Adjust the output volume of the subwoofer.
The current user settings will take priority.
Remedy
Reduce the number of the connected HDMI
components.
Check that the connected HDMI components support
the HDCP copy protection standards.
See
page
15
—
—
15
—
33
—
See
page
—
—