Status Message; Error Message - Yamaha RX-V3800 Bedienungsanleitung

Troubleshooting
iPod
Note
In case of a transmission error without a status message appearing in the front panel and on the video monitor, check the connection to
your iPod (see page 30).

Status message

Loading...
Connect error
Unknown iPod
iPod connected
Disconnected
Unable to play
Auto Setup
Before Auto Setup

Error message

Connect MIC!
Unplug Phones!
No Setup Menu!
Memory Guard!
132
En
Cause
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring
song lists from your iPod.
There is a problem with the signal path
from your iPod to this unit.
The iPod being used is not supported by
this unit.
Your iPod is properly stationed in a
Yamaha iPod universal dock (such as the
YDS-10, sold separately) connected to the
DOCK terminal of this unit, and the
connection between your iPod and this
unit is complete.
Your iPod was removed from a Yamaha
iPod universal dock (such as YDS-10 sold
separately) connected to the DOCK
terminal of this unit.
This unit cannot play back the songs
currently stored on your iPod.
Cause
Optimizer microphone is not connected.
Headphones are connected.
All setup menu are set to "Skip".
"Memory Guard" is set to "On".
Remedy
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Station your iPod back in a Yamaha iPod universal
dock (such as YDS-10 sold separately) connected to
the DOCK terminal of this unit.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel.
Unplug the headphones.
Set the desired menu item to "Check".
Set "Memory Guard" to "Off".
See
page
30
—
—
30
—
—
See
page
37
—
39
95