Yamaha RX-V2600 Bedienungsanleitung Seite 117

Problem
The sound suddenly The protection circuitry has been activated
goes off. because of a short circuit, etc.
The sleep timer has turned the unit off.
The sound is muted.
Only the speaker on Incorrect cable connections.
one side can be
heard.
Incorrect balance settings in the GUI
menu.
Only the center
When playing a monaural source with a
speaker outputs CINEMA DSP program, the source signal
substantial sound.
is directed to the center channel, and the
front and surround speakers output effect
sounds.
No sound from the
The sound field programs are turned off.
effect speakers
You are using a source or program
combination that does not output sound
from all channels.
No sound from the The output level of the center speaker is
center speaker set to minimum.
Center is set to None in Speaker Set.
One of the HiFi DSP programs (except for
7ch Stereo) has been selected.
No sound from the
The output level of the surround speakers
surround speakers is set to minimum.
Surround is set to None in Speaker Set.
A monaural or stereo source is being
played with STRAIGHT.
No sound from the Presence speakers are selected.
surround back
Surround is set to None in Speaker Set.
speakers
Surround Back is set to None in Speaker
Set.
No sound from the
Bass Out is set to Front when a Dolby
subwoofer Digital or DTS signal is being played.
Bass Out is set to SWFR or Front when a
2-channel source is being played.
The source does not contain low bass
signals.
Cause
Check that the impedance selector setting is correct.
Check the speaker wires are not touching each other
and then turn this unit back on.
Turn on the power, and play the source again.
Press MUTE to cancel a mute.
Connect the cables properly. If the problem persists,
the cables may be defective.
Adjust the Speaker Level settings.
Press STRAIGHT (EFFECT) to turn them on.
Try another sound field program.
Raise the level of the center speaker.
Select the appropriate setting for the center speaker.
Try another sound field program.
Raise the output level of the surround speakers.
Select the appropriate setting for the surround left and
right speakers.
Press STRAIGHT (EFFECT) to turn on the sound
fields.
Select Surround Back in PR/SB Priority.
If the surround left and right speakers are set to None,
surround back speakers are automatically set to None.
Select the appropriate setting for the surround left and
right speakers.
Select Small x1, Small x2, Large x1 or Large x2.
Select SWFR or Both.
Select Both.
TROUBLESHOOTING
Remedy
See
page
31
—
—
39
20
86
43
37
86
83
37
86
83
—
79
83
83
85
85
115