Yamaha RX-V2600 Bedienungsanleitung Seite 11

B STANDBY
Sets this unit, Zone 2 and Zone 3 to the standby mode (see
page 30).
Note
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
C POWER
Turns on this unit, Zone 2 and Zone 3 (see page 30).
Note
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
D AUDIO SEL
Toggles the priority for the type of audio input jack
between AUTO, HDMI, COAX/OPT and ANALOG when
one component is connected to two or more input jacks on
the rear panel (see page 44).
E SLEEP
Sets the sleep timer.
F MULTI CH IN
Selects MULTI CH INPUT when using an external
decoder, etc.
G SELECT k / n
Selects another input source that you can control
independently of the input source selected with the input
selector buttons.
H VOLUME +/–
Increases or decreases the volume level.
I AMP/SOURCE/TV
Selects the component you want to control with the
remote control.
AMP
Set to this position to operate this unit.
SOURCE
Set to this position to operate the component selected with
an input selector button.
TV
Set to this position to operate the television assigned to
either DTV or PHONO.
Note
If televisions are assigned to both DTV and PHONO, the one
assigned to DTV takes priority and gets operated when AMP/
SOURCE/TV is set to TV.
y
To set the remote control codes for other components, see
page 98.
J MUTE
Mutes the sound. Press again to restore the audio output to
the previous volume level.
K PURE DIRECT
Turns on or off the PURE DIRECT mode (see page 42).
L EXIT
Exits the GUI mode.
M NIGHT
Turns on or off the night listening modes (see page 42).
N STRAIGHT (EFFECT)
Switches the sound field programs off or on. When
STRAIGHT is selected, 2-channel or multi-channel input
signals are output directly from their respective speakers
without effect processing.
O SPEAKERS A/B
Turns on or off the set of front speakers connected to the
SPEAKERS A and/or B terminals on the rear panel each
time the corresponding button is pressed.
P RE-NAME
Changes the name of the input source in the display
window (see page 102).
Q CLEAR
Clears remote control codes or functions acquired from
the learn, macro and rename features (see page 105).
R LEARN
Programs remote control codes or functions from other
remote controls (see page 100).
S Radio Data System tuning buttons
(U.K. and Europe models only)
These buttons are operational only when TUNER is
selected as the input source.
FREQ/TEXT
Switches the Radio Data System display between the
PS mode, PTY mode, RT mode, CT mode (if the
station offers the corresponding data services) and the
frequency display (see page 53).
PTY SEEK MODE
Sets this unit to the PTY SEEK mode (see page 54).
PTY SEEK START
Starts searching for a station after the desired program
type has been selected in the PTY SEEK mode
(see page 54).
EON
Selects a radio program type (NEWS, INFO,
AFFAIRS, SPORTS) tune in automatically
(see page 55).
CONTROLS AND FUNCTIONS
9