Troubleshooting - Yamaha RX-V2600 Bedienungsanleitung

TROUBLESHOOTING

Refer to the chart below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, set this unit to the standby mode, disconnect the power cable, and contact the
nearest authorized YAMAHA dealer or service center.
■ General
Problem
This unit fails to turn
on when MAIN ZONE
ON/OFF on the front
panel (or POWER on
the remote control) is
pressed, or enters in
the standby mode
soon after the power
has been turned on.
No sound
No picture
114
TROUBLESHOOTING
Cause
The power cable is not connected or the
plug is not completely inserted.
The impedance setting is incorrect.
The protection circuitry has been
activated.
This unit has been exposed to a strong
external electric shock (such as lightning
and strong static electricity).
Incorrect input or output cable
connections.
The optimizer microphone is connected.
The input mode is set to HDMI, COAX/
OPT or ANALOG.
No appropriate input source has been
selected.
Speaker connections are not secure.
The front speakers to be used have not
been selected properly.
The volume is turned down.
The sound is muted.
The input mode is set to ANALOG while
playing a source encoded with a DTS
signal.
The signals this unit cannot reproduce (a
CD-ROM, for example) are being
received from a source component.
The HDMI components connected to this
unit do not support the HDCP copy
protection standards.
Support Audio is set to Other and HDMI
audio signals are not being played back on
this unit.
Conversion is set to Off.
Video signals in the progressive format or
HDTV video signals are being input.
The signals input at the HDMI IN 1 or
HDMI IN 2 jack are being output at the
HDMI OUT jack.
Remedy
Connect the power cable firmly.
Set the impedance to match your speakers.
Make sure all speaker wire connections on this unit
and on all speakers are secure and that the wire for
each connection does not touch anything other than
its respective connection.
Set this unit in the standby mode, disconnect the
power cable, plug it back in after 30 seconds and then
use it normally.
Connect the cables properly. If the problem persists,
the cables may be defective.
Disconnect the optimizer microphone.
Set the input mode to AUTO.
Select an appropriate input source with INPUT,
MULTI CH INPUT or the input selector buttons on
the remote control.
Secure the connections.
Select the front speakers by pressing
SPEAKERS A or B on the front panel (or by pressing
SPEAKERS A or B on the remote control).
Turn up the volume.
Press MUTE or any operation buttons of this unit to
cancel a mute and adjust the volume.
Set the input mode to AUTO or COAX/OPT.
Play a source whose signals this unit can reproduce.
Connect HDMI components that support the HDCP
copy protection standards.
Set Support Audio to RX-V2600 in HDMI Set.
Set Conversion to On.
See
page
—
31
15
—
20–28
—
44
37
15
37
—
39
44
—
—
92
81