Husqvarna CT151 Anleitungshandbuch Seite 24

2
1. Frontbaggertube
2. Lowerbaggertube
3. 1/4 x 50,8mm Carriage
Bolts
4. 1/4 Lock nut
1.
2.
3.
4.
5.
6.
7.
8.
2
Front bagger tube
1_-
1/4 x 50,8mm Carriage
Bolts
1/4 Lock nut
Vinyl Binding
Dump handle tube 6MM (1/4") - gMM (3/8")
Clevis pin
Retainer spring
Cap
1
1. TopSurfaces Even
2. Horizontal Adjustment Bracket
3. VerticalAdjustment Bracket
_)
To Assemble
Begger
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person when putting the bagger to-
gether.
• Holes in front ba_]ger tube are at an angle, Race front
bagger tube against lower bagger tube and check for
proper hole alignment before assembling belts.
• Assemble front and lower bagger tubes using four (4)
1/4 x 50,8mm carriage bolts and lock nuts supplied.
Tighten securely.
• Slide front and lower bagger tube assembly into the bag-
ger assemby.
• Assemble front and upper bagger tubes using four (4)
1/4 x 50,8ram carraige bolts and lock nuts supplied.
Tighten securely,
• Slip all the vinyl bindings over the bagger tubes
• Slide the bagger dump handle through the hole in the
bag.gertop, install the clevis pin and secure with retainer
spnng.
Push cap over end of bagger dump handle.
NOTE: For future use, the clevis pin may be removed in order
to use the handle to clear the chute in the event it has become
clogged.
Bagger adjustment
For properbag function and appearance,it may be necee.
sery to adjustthe bagger assembly. T here shouldbe 6mm
(1/4")-gmm(3/8")gap betweenthebaggertopandfender and
the bagger top surfaceshouldbe even with the top surface
of the fender. To adjustbagger position:
Horizontal adjustment
Slightlyloosenthe nutssecuringthe bagger RH and LH
horizontal a djustmentbrackets.Loosen onlyenoughso
the bracketskeep their position,but allowthem to be
moved.
Move the brackets the amountforward or backwardyou
wish the bag assemblyto move.Retightenthe nutsse-
curely.
Vertical adjustment
• Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep their
position, but allow them to be moved,
• Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
• Reinstall the bagger assembly and check the bagger to
fender fit. If necessary, repeat the procedure until proper
fit is attained.
To convert to bagging, mulching or discharge
See "Section 5" of this manual,
24