Husqvarna CT151 Anleitungshandbuch Seite 23

2
_To Install bagger components to tractor
1
1. DischargeChute
2. :3/8Nut
3. Flat Washer
4
1. SupportBracket
2, Clevis Pin 10 x 17mm
3. RetainerSpring
4. Clevis Pin 10 x 50mm
5. 10,3mm (13/32") flat
washer
5
3
1
• Removedischargechutefmmrearoftractor. U nhookthe
two (2) strapsand pullchute out and away from tractor.
• Removethe two (2) 3/8 nutsand flat washersfrom the
bolts at the tractorbackplate.
• Installthe two upper supportbracketsthroughthe back
plate and to the chassis,installthe clevispin 10x17mm
and secure withretainerspring.
• Assemble both support bracketsto the outside of the
bagggersupporttube install t he clevispin 10x50mmand
secure with retainerspring.
1. 3/8 Locknut
2. Flat Washer
3. SupportTube
1
• Using the nuts and fiat washers removedfrom tractor
back plate, installthe bagger supporttube to the back
plate as shown. T ightensecurely.
1. Hook
2. DischargeChute
3, Backplate slot
3
• Replace dischargechute into rear opening of tractor.
Secure the chutewiththe two hookstraps.
NOTE: The strap hookmustgo throughthe dischargechute
only.Do not allow the hook to enter the slot in the tractor
back plate.Thiswillallowthe dischargechuteto float withthe
mowerdeckwhen movingon uneventerrain.
23