Inserting The Flow Cell; Fig. 6 Inserting The Flow Cell - Knauer Azura DAD 2.1L Benutzerhandbuch

18 Installation
Process
1. Set-up the package in such a way that you can read the
label. Using the utility knife, cut the adhesive tape and
open the packaging.
2. Remove the foam insert. Take out the accessory kit and the
manual.
3. Open the accessory kit and check the scope of delivery. In
case any parts are missing, contact the Technical Support.
4. Clasp the device from below, lift it out of the packaging
and place it on its feet. Do not hold onto the front cover.
5. Check the device for signs of damage that occurred during
transport. In case you notice any damage, contact the
Technical Support.
6. Place the device in its site of operation and remove protec-
tive foil.
Next steps Store packaging and keep the included packing list for repeat
orders.
Note The test cell is used during operation qualifications and must be
stored.

Inserting the Flow Cell


Prerequisite No flow cell or test cell is installed.

The device is switched off.

Procedure Insert the flow cell.
Note Pay attention to the compatibility of the flow cells.
Procedure Process
1. Place the flow cell into
the opening and slide
to the back until it
clicks into place inside
the device.
Next steps Connect the capillaries.
KNAUER DAD 6.1L, DAD 2.1L, MWD 2.1L User Manual V6700, Version 1.0
WARNING! 
Irritation of retina through UV light! Concen-
trated UV light can leak out from the flow cell or
the fiber optic connectors.
Switch off the device or the lamps.
Figure
Fig. 6 Inserting the Flow Cell