Connecting The Cables; Configuring The Router; Fig. 18 Cabling System Lan - Knauer Azura DAD 2.1L Benutzerhandbuch

24 Installation
a) Obtain IP address automatically
b) Obtain DNS server address automatically
7. Click on the button OK.

Connecting the Cables

A router has several LAN ports and one WAN port that can be
used to integrate the LAN into a wide area network (WAN), e.g.
a company network or the Internet. In contrast, the LAN ports
serve to set up a network from devices and a computer. To
avoid interference, we recommend operating the HPLC system
separately from the company network.
You will find patch cables for each device and the router in the
accessories kit. To connect the router to a WAN, an additional
patch cable is required, which is not supplied within the scope
of delivery.
Legend
Modules
1
Router
2
LAN ports
3
Fig. 18

Prerequisite The computer has been switched off.

There is a patch cable for each device and the computer.
Procedure 1. Use the patch cable to connect the router and the computer.
Repeat this step to connect all devices.
2. Use the power supply to connect the router to the mains
power system.

Configuring the Router

The router is preset at the factory. You will find a label at the
bottom side of the router, on which IP address, user name, and
password are printed. These information help to open the router
configuration.
Procedure 1. To open the router configuration, start your Internet browser
and enter the IP address (not for all routers).
2. Enter user name and password.
KNAUER DAD 6.1L, DAD 2.1L, MWD 2.1L User Manual V6700, Version 1.0
4
5
1 2 3
Cabling system LAN

WAN port
Workstation
5
4