Installing The Deuterium Or Halogen Lamp; Fig. 36 Lamp Pod Of The D2 Lamp; Fig. 37: Lamp Pod Of The Halogen Lamp; Fig. 38 Installing The Deuterium Lamp - Knauer Azura DAD 2.1L Benutzerhandbuch

55 Maintenance and Care

Installing the Deuterium or Halogen Lamp

Removing the lamp cover switches off the device.

Prerequisites The device is switched off.

The lamp cover has been removed.

The old lamp has been removed.
Tool Screwdriver Allen wrench, 2.5 mm
Procedure Process
1. Hold the lamp at the
lamp socket and
guide the glass body
into the lamp pod
1
2. The bolt
deuterium lamp sits
in a notch in the
lamp socket.
Note
Insert the halogen lamp
into the lamp pod at
3
a slight angle.
3. Using the screw-
driver, tighten the
two screws
on the lamp socket.
4. Connect the plug
or
the lock ring.
KNAUER DAD 6.1L, DAD 2.1L, MWD 2.1L User Manual V6700, Version 1.0
CAUTION! 
Damage to the lamp and inaccurate measuring
results due to residue possible!
Do not touch the glass body with your hands!
Wear gloves.
Use a clean, soft cloth.
Figure
.
of the
2
Fig. 36
Fig. 37
or
4 7
5
and tighten
6
Fig. 38
Lamp pod of the D2 lamp
3
Lamp pod of the halogen
lamp
Installing the deuterium
lamp
1
2
4
5
6
7