Connecting The Device To The Computer; Configuring The Lan Settings; Fig. 17 Control Unit Port On Dad 6.1L - Knauer Azura DAD 2.1L Benutzerhandbuch

DAD 6.1L
USB port for the
1
Control Unit
Note
Process
Prerequisite
Procedure
KNAUER
23 Installation
Fig. 17 Control Unit port on DAD 6.1L

Connecting the Device to the Computer

This section describes how to set up an HPLC system in a local
area network (LAN) and how a network administrator can inte-
grate this LAN into your company network. The description
applies to the operating system Windows® and all conventional
routers.
To set up a LAN, we recommend to use a router. That means
the following steps are required:
1. On the computer, go to the control panel and check the LAN
properties.
2. Hook up the router to the devices and the computer.
3. On the computer, configure the router to set up the network.
4. Install the chromatography software from the data storage
device.
5. Switch on the device and run the chromatography software.

Configuring the LAN Settings

The LAN uses only one server (which is normally the router)
from that the devices automatically receive their IP address.
®

In Windows , power saving, hibernation, standby, and
screen saver must be deactived.

In case you use an USB-to-COM box, the option "Allow the
computer to turn off ths device to save power" in the device-
manager must be deactivated for all USB hosts.

Only for Windows 7: For the network adapter, the option
"Allow the computer to turn off this device to save power" in
the Device Manager must be deactivated.
1. In Windows 7 choose Start
Sharing Center.
2. Double-click on LAN Connection.
3. Click on the button Properties.
4. Select Internet Protocol version 4 (TCP/IPv4).
5. Click on the button Properties.
6. Check the settings in the tab General. The correct settings for
the DHCP client are:
DAD 6.1L, DAD 2.1L, MWD 2.1L User Manual V6700, Version 1.0
5
 
Control Panel Network and