Procedure
Next steps
Legend
Integrator outlets
1
LAN connector
2
Service interface
3
Pin header
4
KNAUER
22
Installation
Process
5. For the bottom device,
push the short end of
the nozzle
6
opening in the collec-
tion point of the leak
tray.
6. Connect the hose to
the nozzle and lead the
second ending to the
waste bottle.
7. Place the waste bottle
below the bottom
device.
Attach the front cover.
Control
The detector can be controlled externally in two ways:
Via pin header
As part of a LAN, via the LAN connector of the router
All connectors for external control are located on the rear side of
.
the detector
The DAD 6.1L can also be controlled via the Control Unit. The
Control Unit connector is located on the side of the device.
1
Fig. 16
Connectors on rear side
DAD 6.1L, DAD 2.1L, MWD 2.1L User Manual V6700, Version 1.0
Figure
into the
Fig. 15
Leak tray with nozzle
2 3
4
6