Disc Menu Screen; Input Select Menu Screen - JVC BD-X200E Bedienungsanleitung

Setup Menu

DISC MENU Screen

The following table identifies and describes the parameters that may be set using the DISC MENU screen.
Top half : Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ] : Default setting
Parameter Possible settings
FINALIZE
FINAL
CANCEL DISC
FINALIZATION
CAN FIN
DISC ERASE
(QUICK)
q ERASE
DISC ERASE
(FULL)
F ERASE
MENU

INPUT SELECT MENU Screen

The following table identifies and describes the parameters that may be set using the INPUT SELECT MENU screen.
Top half : Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ] : Default setting
Parameter Possible settings
INPUT SELECT
INPUT
MENU
E-86
[CANCEL] This parameter indicates whether or not the recorded disc is to be finalized. If a disc
EXECUTE recorded using this DVD recorder is to be played on a DVD player, it must first be
finalized. Once finalizing has been carried out, no addition recordings can be made
on the disc.
[CAN] CANCEL
EXE EXECUTE : Finalizing is to be carried out.
[CANCEL] Select whether to cancel the finalization of a finalized DVD-RW. To add a recording
EXECUTE to a finalized DVD-RW set to EXECUTE. A DVD-RW finalized on another machine
cannot be canceled.
[CAN] CANCEL
EXE EXECUTE : Cancel the finalization. The TOP MENU created during finalization is
[CANCEL] Select whether to do a quick erase on a DVD-RW (video mode). A quick erase only
EXECUTE deletes the DVD-RW disc control area. The time required is shorter than a full erase,
and the disc data is deleted.
[CAN] CANCEL
EXE EXECUTE : Do a quick erase. The disc can be newly recorded from the beginning.
[CANCEL] Select whether to carry out a full erase on a DVD-RW (video mode). All areas of a
EXECUTE DVD-RW disc are deleted. If a disc is to be used repeatedly delete using this item.
CANCEL
[CAN] EXECUTE : Do a full erase. The disc can be newly recorded from the beginning.
EXE
This button is used to return to the Setup Menu screen.
[LINE] This parameter is used to select the audio and video input signals.
Y/C LINE : The composite video signal from the VIDEO LINE IN terminal and the analog
DV
Y/C : The YC separate signal from the Y/C IN terminal and the analog audio signals
DV : The digital video and audio signals from the DV IN/OUT terminal are to be
[LINE]
YC * The front-panel indicator corresponding to the type of input signal selected on this
dV screen will light up or start to flash.
Setting of this parameter will not be possible when REMOTE SELECT from the
REMOTE MENU screen has been set to DV(MASTER), DV(SLAVE), or
DV(TRIGGER). DV signals will be used for input at these times
This button is used to return to the Setup Menu screen.
: Finalizing is not to be carried out.
It will be necessary to close all titles on a disc before it can be finalized.
* A maximum of 20 minutes will be required to complete finalizing.
: Do not cancel the finalization.
deleted.
: Do not do a quick erase.
: Do not do a full erase.
audio signals from the AUDIO IN terminals are to be used.
from the AUDIO IN terminals are to be used.
used.
Description
Description