Disc Menu Screen; Input Select Menu Screen - JVC BD-X200E Bedienungsanleitung

DISC MENU Screen

The following table identifies and describes the parameters that may be set using the DISC MENU screen.
Top half : Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ] : Default setting
Parameter Possible settings
FINALIZE [CANCEL]
EXECUTE
FINAL [CAN]
DISC ERASE [CANCEL]
EXECUTE
ERASE [CAN]
MENU

INPUT SELECT MENU screen

The following table identifies and describes the parameters that may be set using the INPUT SELECT MENU screen.
Top half : Appearance on monitor screen
Bottom half : Appearance on LCD display
[ ] : Default setting
Parameter Possible settings
INPUT SELECT [LINE]
INPUT [LINE]
MENU
All manuals and user guides at all-guides.com
This parameter indicates whether or not the recorded disc is to be finalized. If a disc
recorded using this DVD recorder is to be played on a DVD player, it must first be
finalized. Once finalizing has been carried out, no addition recordings can be made
on the disc.
CANCEL : Finalizing is not to be carried out.
EXECUTE : Finalizing is to be carried out.
EXE
It will be necessary to close all titles on a disc before it can be finalized.
* A maximum of 20 minutes will be required to complete finalizing.
This parameter indicates whether or not a DVD-RW (video mode) is to be erased.
CANCEL : This disc is not to be erased.
EXECUTE : This disc is to be erased. In this process, all recorded data is erased
from the disc, and it can then be recorded to as a new disc.
EXE
This button is used to return to the Setup Menu screen.
This parameter is used to select the audio and video input signals.
Y/C LINE : The composite video signal from the VIDEO LINE IN terminal and the analog
DV audio signals from the AUDIO IN terminals are to be used.
Y/C : The YC separate signal from the Y/C IN terminal and the analog audio signals
from the AUDIO IN terminals are to be used.
DV : The digital video and audio signals from the DV IN/OUT terminal are to be
used.
YC * The front-panel indicator corresponding to the type of input signal selected on this
screen will light up or start to flash.
DV
Setting of this parameter will not be possible when REMOTE SELECT from the
REMOTE MENU screen has been set to DV(MASTER), DV(SLAVE), or
DV(TRIGGER). DV signals will be used for input at these times
This button is used to return to the Setup Menu screen.
Description
Description
E-77