Checking The Video Input - JVC BD-X200E Bedienungsanleitung

Settings & Controls for Recording

Checking the Video Input

Use the monitor connected to the VIDEO LINE OUT terminal to confirm that the input video signal is as required.
The following procedure will allow you to monitor the quality at which the video will be recorded to a DVD.
DVD RECORDER BD-X200
TITLE CHAPTER
DOLBY DIGITAL
LPCM MPEG
REV STOP PLAY FWD PAUSE REC
REC button
The bit-rate setting value is
indicated on the LCD display.
ENCODING XX
Bit-rate value
E-38
VIDEO LINE OUT terminal
VIDEO
IN LINE
Y/C
IN
DV IN/OUT
LAN
SIGNAL
GND
Signal Connections
Connect the VIDEO LINE OUT terminal to the monitor.
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
SET UP
SET
TOP
MENU MENU
Audio will be muted at this time.
AUDIO
OUT INPUT CH1
LEVEL
IN OUT
4dB
8dB
CH2
REMOTE
USB
DC 19V
Procedure
Press and hold the REC button for at least 2 seconds while the DVD
recorder is stopped or inserted with no disc. While this button is being
held, input signal encoded/decoded in MPEG will be output via the VIDEO
OUT terminal on the rear panel.
● This function allows the quality of the video to be confirmed before recording
to a DVD.
Note
Monitor screen