Playing Back A Finalized Disc - JVC BD-X200E Bedienungsanleitung

Playback

Playing Back a Finalized Disc

This DVD recorder can also be used to playback discs that it has recorded and finalized.
When a disc is finalized, its title menu will be used to create the top menu.
The action taken by your BD-X200 when a disc it has finalized is inserted or when playback of a title has ended will depend on the
settings of DISC IN ACTION and TITLE END as set on the RECORDER MENU (2/2) screen during recording.
* Playback may not proceed smoothly with discs recorded using different devices, regardless of whether or not they have been
finalized.
Caution
● During playback of a disc, if the input setting
is DV then the sound can be delayed. In this
case, change the input setting to LINE or Y/
C.
● If the disc is dirty or damaged good playback
may not be possible. In this case either clean
the disc or change it.
1.
Insert a disc.
Depending upon the INTRODUCTION TITLE item and the DISC IN ACTION item settings of the RECORDER MENU (2/2)
screen during recording, the operation will differ. Operate in accordance with the table below. (For the operation with a disc
with a DVD MENU TYPE item set to NONE, refer to page 61.)
The action set in the DISC IN ACTION item is carried out.
(See below.)
The title menu will appear
2.
Select the number of the title to be played.
Use the t, 8, 7, and 6 buttons to select the title number
for playback.
3.
Press the SET button to begin playback.
4.
Set to Still mode.
This is done by pressing the PAUSE button.
● The DVD recorder enters Still mode.
● If the PAUSE button is then pressed again in Still mode, the DVD recorder will advance playback by a single frame.
5.
Restart playback.
Press the PLAY button.
The DVD recorder will behave as follows when title playback has ended.
These actions will depend on the setting made for TITLE END from the RECORDER MENU (2/2) screen during recording.
Set to MENU
Enters stop mode and the
title menu (TOP MENU) is
displayed.
6.
Stop playback.
This is done by pressing the STOP button.
● The DVD recorder enters Stop mode.
E-60
INTRODUCTION TITLE item setting during recording
Set to OFF
DISC IN ACTION setting made during recording
MENU
TITLE END item setting during recording
Set to REPEAT
Repeats playback within
the title.
OPERATE
DVD RECORDER BD-X200
AUDIO
TITLE CHAPTER
CH1
DOLBY DIGITAL
LPCM MPEG
CH2
PHONES REV STOP PLAY
STOP button
PLAY button
The introduction title (opening movie) is automatically played.
After playback is finished, the action set in the DISC IN ACTION
item is carried out. (See below.)
Playback starts automatically from the first title.
Set to STOP
Enters the stop mode. The
title menu (TOP MENU) is
not displayed.
Note
When the introduction title (opening movie) is played on another DVD
player only the STOP button is accepted.
BUSY
OPEN/CLOSE
OPTION DV Y/C LINE
SET UP
SET
FWD PAUSE REC TOP
MENU MENU
PAUSE button SET button
Set to ON
TITLE
Set to NEXT TITLE
Next title is played. When playback
of the final title finished, the first title
is played. (Disc repeat playback)
Cursor buttons
(t, 8, 7, and 6)