Operation Modes - ABB Sensyflow FMT500-IG Inbetriebnahmeanleitung

10.1.1 Operation modes

OPERATION MODE
►
STANDARD
SPECIALIST
►
PASSWORD
SPECIALIST
►
SPECIALIST
►
IMPORTANT (NOTE)
When the SPECIALIST or SERVICE (for manufacturer's Service department only) modes are
activated, the outputs and totalizer will be frozen (i.e., the last value will be retained) when the
menu is opened. As soon as you return to the STANDARD operation mode or one of the
display modes, the outputs will be re-enabled and the totalizer will start running again.
If no entries are made for a period of 2 minutes, the device will automatically revert to display
mode and the STANDARD operation mode. If this happens, any unsaved changes will be lost.
CI/FMT500-IG-X1
000_
+
< >
2000
Sensyflow FMT500-IG
PROFIBUS DPV1 parameterization
Display of parameters, cannot be changed.
Changes can only be made in the SPECIALIST and
SERVICE modes, which are password-protected.
To access these, use
(When PROFIBUS communication is active, it is not
possible to make parameter changes on the device).
Use and to select the required mode:
STANDARD, SPECIALIST or SERVICE.
Use to confirm your selection.
(PASSWORD SPECIALIST: 2000 )
Use and to position the cursor.
Use to set the numerical value.
Use to complete password entry.
(Cursor must be positioned on the far
right).
OK will appear to confirm that the password is
correct.
Use and to access additional menus.
.
EN - 47
101