Parameter Changes - ABB Sensyflow FMT500-IG Inbetriebnahmeanleitung

HART parameterization
9.1.2

Parameter changes

To save parameter changes, you need to perform 3 separate operations:
1. Enter password (OPERATION MODE)
2. Make changes to parameters in the menus
3. Save
Changing text and values
The process will be illustrated on the basis of the TAG NO. This input mask can be found in the
PARAMETER MENU and can be accessed from any display mode using
Entries and changes can only be made in the SPECIALIST or SERVICE operation modes (see
Section 9.1.1, "Operation modes").
►
►
►
►
44 - EN
98
NITROGEN
PARAMETER MENU
TAG NO LONG
SENSYFLOW-IG 123
< >
TAG NO LONG
SENSYFLOW-IG 123
Sensyflow FMT500-IG
Press 3 times.
T: 27 °C
5,
kg/h
942
✳
Press.
Press.
Press.
Press.
Press.
+
To make the entry, use
and
character). To complete the entry process, the
cursor must be moved to the right of the input field
(16 characters in the example). Only when the
cursor is in this position will
to
exit change mode by pressing
The display will revert to the PARAMETER MENU,
where you can make additional configuration
changes.
,
(to set the numerical value or required
+
on the display, making it possible to
and .
(cursor position)
change back
.
CI/FMT500-IG-X1