Receive 20 Khz-Band Normal Squelch Tuning - Motorola P100 Serie Servicehandbuch

5-16
F1
F2
F3
F4
F5
5.7.4 Receive 20 kHz
1. Under the Alignment menu, select Rx Squelch, then select Squelch 20 kHz-band Normal.
(Figure 5-12. Rx 20 kHz-band Normal Squelch Tuning Window).
2. Apply a RF signal (with 1 kHz tone at 1.5 kHz deviation) for current frequency point with minimum
amplitude, -128 dBm (F1 being the first).
3. Set softpot to minimum (0) and adjust the amplitude of RF signal to the SINAD Reading (6 – 8 dB)
(as shown in Table 5-5.) on the test equipment.
4. Adjust the softpot value by using either the Right arrow on the slider or Up arrow on the Working
Softpot box until the radio is totally muted.
5. Adjust the softpot value by using either the Left arrow on the slider or Down arrow on the Working
Softpot box until the radio is totally unmuted.
6. Repeat steps 2–5 for F2–F5.
7. Press Program to commit the softpot values into the codeplug.
Figure 5-11. Rx 12.5 kHz-band Tight Squelch Tuning Window
Band Normal Squelch Tuning
-
Radio Programming and Tuning: Receiver Tuning