Herunterladen Inhalt Inhalt Diese Seite drucken

Front Circuit Board, Display Module And Keypad Reassembly - Motorola P100 Serie Servicehandbuch

Handfunkgeräte
Vorschau ausblenden Andere Handbücher für P100 Serie:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 167
6-14

6.5.2.2 Front Circuit Board, Display Module and Keypad Reassembly

1. Place and align the LCD (33) onto the front housing.
2. Place and align the Keypad (38) onto the keypad slot. Apply force around the keypad and ensure
the keypad sealing rib is perfectly seated onto the keypad slot. (Refer Figure 6-15).
3. Place the Front Circuit Board (36) straight down on top of the LCD and keypad. Align the front
circuit board to the four housing ribs. Press the top right edge of the front circuit board to ensure
the microphone sealing rubber is fully seated in place.
4. Tighten the five screws holding the front circuit board with a Phillips screwdriver torque to
1.2 kgf – 1.5 kgf. (Refer Table 6-3 on page 6-17 for torque in other units).
5. Insert the LCD flexible cable into the connector on the front circuit board.
6. Push the latches into the connectors.
Maintenance – Full Keypad Models:Disassembling and Reassembling the Radio
Figure 6-15. LCD and Keypad Reassembly
Figure 6-16. Front Circuit Board Reassembly
LCD
Keypad
Circuit Board

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis