Motorola P100 Serie Servicehandbuch Seite 104

6-16
B
Figure 6-18. Main Circuit Board, Finger Strips, O-ring and Battery Contact Seal Reassembly (UHF2)
7. Insert the Sub Circuit Board Flexible Cable (11) into the respective connectors at the top of the
main circuit board.
8. Push the latches into the connectors.
9. Place the sub circuit board straight down on top of the chassis.
10. Tighten the screw that is holding the sub circuit with a Phillips screwdriver torque to
2.2 kgf – 2.5 kgf. (Refer Table 6-3 on page 6-17 for torque in other units).
11. Tighten the nut on the On/Off Volume Knob Shaft with the Crab Eye Nut Opener.
12. Align and Insert the Accessory Bracket (30) into the audio jack hole. (Refer Figure 6-19).
Figure 6-19. Sub Circuit Board and Accessory Bracket Reassembly
Maintenance – Full Keypad Models:Disassembling and Reassembling the Radio
C
Accessory Bracket
Audio Jack
A