Chassis Assembly Disassembly; Figure 8-8. Sub-Circuit Board And Accessory Bracket Removal - Motorola P100 Serie Servicehandbuch

8-10
f. Push the latches on the Front Circuit Board (36) sideways to the right to release the
flexible cable from the connector. (Refer Figure 8-7).
Latches

8.5.1.2 Chassis Assembly Disassembly

1. Remove the Accessory Bracket (31).
2. Remove the nut (14) on the On/Off Volume Knob Shaft and Channel Knob Shaft with the Crab
Eye Nut Opener.
3. Remove the screw holding the Sub Circuit Board (13) to the Chassis (23) with a Phillips
screwdriver.
4. Push the latches on the Main Circuit Board (16) to release the Flexible Cable (34) from the
connector.
5. Remove the Sub Circuit Board from the Chassis. (Refer Figure 8-8).
Nuts
Latch
6. Remove the six screws (33) holding the Main Circuit Board to the Chassis with a Phillips
screwdriver. Remove the RF Support Screw (17) with a flat head screwdriver.
Maintenance – Non Keypad Model: Disassembling and Reassembling the Radio
Figure 8-7. Unlatch the Flexible Cable

Figure 8-8. Sub-Circuit Board and Accessory Bracket Removal

Accessory Bracket
Sub Circuit Board