Automatic Search; Status; Status Cmd: Start Automatic Search - Maico Rv 2 Rls 45 K Installations- Und Inbetriebnahmeanleitung

30 RV / CPP devices settings menu (specialist installers)

30.10 Automatic search

See also chapter Automatic search (Plug & Play)
[} 78].
Parameters Setting value

Status

The current status of the search
function (off, searching or finished)
is displayed. No settings can be
made.
CMD status Automatic search for addressing
and grouping connected RV 2
devices.
Devices List of the RV and CPP ventilation
found devices found with their device ad-
dresses.
30.10.1 Status
The current status of the search function is dis-
played:
Off No search active.
Searching The search is currently being
performed. Message only visible
if the function was started from
the RLS 45 K.
Complete The search has been completed.
94

30.10.2 Status CMD: Start automatic search

Off End search/deactivate search (factory
setting).
Start Start automatic search.
Delete Delete the list of devices found.
list
Adopt Manual transfer of the devices found
after an error message.
A maximum of 8 RV 2 ventilation devices + 8
CPP 60 ventilation devices can be connected to
one master controller (provided that sufficient PP
45 LT power units are available).
The devices found are stored in a list in ascend-
ing order based on the device address. Other
units are ignored and not saved in the list.
Even with an uneven number of ventilation
devices, these can be configured automatically
with the commissioning software.
A successful search is signalled by a green info
window with the following message: "A valid con-
figuration was found. The devices were success-
fully assigned."
If no unit is found or an address is used more
than once, the search is deemed to have failed.
The failed search is signalled by a red info win-
dow with the following message: "An invalid con-
figuration was found. Please accept and configure
manually."