coldline VISION W5S Bedienungs- Und Wartungsanleitungen Seite 63

11.0 UTILITIES
While the cycle is in progress, the display will show the temperature of air inside
the cell. It is possible to view the temperature of the core probe by touching the
centre of the display where the temperature in the cell is displayed.
In the top left corner there is the
percentage. By pressing on the icon, it will be possible to change the ventilation
percentage during the current cycle.
In the top right corner there is the
alongside. By pressing on the icon it will be possible to change the temperature
of the cycle in progress
In the bottom left corner there is the
4°C. By pressing on the icon it will be possible to adjust the humidity rate or not
manage the parameter (OFF).
Pressing on the icon will start a manual defrost cycle.
Pressing on the icon, the display will be locked to prevent tampering or to
clean the door while a program is running. Just hold down a point on the display
to unlock it.
Below the cycle progress time there is the
will be possible to set a visual and sound alert for the following parameters:
- Core probe
- Cell temperature
- Time
See this in par. 26.0 General indications for use
The UTILITIES menu allows you to start a defrosting cycle, perform sanitization,
heat the core probe (optional), export the HACCP data, update the software, back
up the data and view the alarm log.
icon next to the set ventilation
icon with the temperature set for this cycle
icon if the set temperature is above
icon. By pressing on the icon it
63