coldline VISION W5S Bedienungs- Und Wartungsanleitungen Seite 57

Ventilation: depending on the programs, by selecting the ventilation field,
you can change it or the automatic management symbol
which case it will be possible to change the ventilation only from the
program editor
Set cell temperature: depending on the programs, by selecting the Set cell
temperature field you can edit it or the automatic management symbol will
appear, in which case it will be possible to change the setting only from the
program editor.
Humidity: if the temperature is higher than 4°C it will be possible to change
the humidity of the cell (humidification or dehumidification in blast chillers
and proofer-retarders, while storing units, having no humidification system,
allow humidity regulation by dehumidifying the cell). By selecting the
humidity symbol , you can set the desired humidity or, in case of
automatic management, the change will be possible from the program
editor.
Program editor or manual defrost symbol: depending on the program, the
symbol to modify the programming or start an automatic defrost cycle will
appear in the bottom left (in remote models, defrosting will be carried out
with the door open). In automatic cycles and appliances with on-board
refrigeration unit, defrosting is automatic.
Remaining time/elapsed time: indicates the time remaining in the time
programs and the time spent in the probe programs or in the manual cycle
Alert: When a program is started, by selecting the bell symbol at the
bottom, it is possible to set an alert:
- Upon reaching a certain core temperature
- Upon reaching a certain temperature in the cell
- After a set time
This function is useful if it is necessary to set an intermediate process on the
food placed inside the appliance.
Phase indication: the text and the bar indicate the phase the program is
performing
Stop key: interrupts the program; if it has been modified, the save request
will appear.
Hide: once the desired program has been selected, by pressing this symbol,
it is possible to hide a pre-installed recipe. To make it reappear, simply
repeat the same operation.
will appear, in
57