ECOLAB EcoUp Betriebsanleitung Seite 143

7 Setup
Personnel:
Protective equipment:
DANGER!
Personal protective equipment, hereinafter referred to as PPE, is used to
protect personnel. It is imperative to pay attention to the PPE described in
the product data sheet (safety data sheet) for the metered medium.
NOTICE!
Material damage by using incorrect tools!
Material damage may arise by using incorrect tools. Use the correct tools.
DANGER!
– The initial start-up may only be performed by authorised personnel who are
familiar with how to operate the metering system.
– Initial start-up must be documented and the settings made recorded in the
log.
– Before putting the system into operation, check that your installation
(
assembled correctly to ensure the stability and secure position of the
equipment.
– Check that the entire metering system is sealed to prevent the escape of
chemicals and the resulting risk to personnel and the environment.
– Should you have any questions about commissioning, please contact us at:
Ä Chapter 1.8 'Contact' on page 11
Risk of slipping
WARNING!
Risk of slipping due to fluid in the operation and provisioning area!
– Wear non-slip, chemically resistant shoes when working.
– Place product containers in a tank to prevent a slipping hazard caused by
leaking fluids.
ENVIRONMENT!
Leaked, spilled metering media must be cleaned and disposed of correctly,
according to the instructions on the safety data sheet. It is essential to ensure
that the required personal protective equipment (PPE) is used.
n Service personnel
n Specialist
n Operator
n Protective gloves
n Chemical-resistant protective gloves
n Protective eyewear
n Safety shoes
Ä Chapter 6 'Assembly and connection' on page 27 ) has been
45
Setup
MAN049656 Rev. 3-01.2024