ECOLAB EcoUp Betriebsanleitung Seite 149

8 Operation
Personnel:
Protective equipment:
Switching the pump on and off
After being switched on, the pump requires approx. 250 milliseconds to reach
operational readiness. We do not therefore recommend intermittent control of
the pump using the mains voltage. Use the enable input for this purpose (see
Ä '[Enable] "external enable" ' on page 44 ).
Fig. 15: On/off button of the 'EcoUp'
Rotary knob for adjusting the dosing quantity
1
Locking of the dosage rate adjustment
2
LED – Alarm signal, flashing red
3
LED operating mode
4
LED operating status / metering mode "viscosity low"
5
1.
Use the On/Off button
2.
After the pump has been switched on, you can set the viscosity level:
Ä 'Switch to metering mode' on page 52
See
n Operator
n Specialist
Chemical-resistant protective gloves
n
n Protective eyewear
n Safety shoes
4
5
7
8
( Fig. 15 ,
Depending on the selected metering mode, either the left LED ( Fig. 15 ,
, Viscosity low) or the right LED ( Fig. 15 ,
5
or flashes.
In 'Standby' mode, the corresponding LED lights green. As soon as the
pump start metering, it flashes yellow.
1
2
3
6
9
LED operating status / metering mode "viscosity high"
6
Button for switching between manual/pulse mode
7
On/off switch
8
Test button
9
) to switch the pump on and off.
8
6
51
Operation
, Viscosity high) lights up
MAN049656 Rev. 3-01.2024