ECOLAB EcoUp Betriebsanleitung Seite 145

1
6
5
2
4
3
7
9
8
Fig. 13: Controller for 'EcoUp'
1.
Install the mounting plate and pump in the required location and installation scenario.
Ä 'Installation variants' on page 29
2.
Make the hydraulic connections.
Ä Chapter 6.2.1 'Hydraulic installation' on page 32
3.
If necessary, make the electrical connections for signal inputs.
Ä Chapter 6.2.2 'Electrical installation' on page 40
4.
Connect the mains plug (fitted at the factory) to the power supply.
5.
Switch on the pump using the On/Off button
6.
Change the viscosity by pressing the On/Off
(for about 3 seconds).
The pump must be switched off to change operating modes.
ð The LED that corresponds to the selected viscosity briefly flashes green.
7.
Switch on the pump by pressing the on/off button
ð The pump resumes operation and the LED for the new viscosity setting flashes.
8.
The first time you use the pump:
n Bleed the pipes
see Ä Chapter 7.3 'Venting the metering pump' on page 49
n Perform a volumetric measurement of the pump:
Ä Chapter 7.4 'Volumetric measurement for the pump' on page 50
Rotary knob for adjusting the dosage rate
1
Locking mechanism for fixing the rotary button in place
2
LED – Alarm signal, flashing red
3
LED – Mode indicator
4
LED – Operating status / metering mode: Viscosity low
5
LED – Operating status / metering mode: Viscosity high
6
Button to switch between Manual/Pulse mode
7
On/Off switch
8
Test button
9
.
and 'Test'
.
47
Setup
buttons simultaneously
MAN049656 Rev. 3-01.2024