KKT KOLBE IND800DRAFT Benutzerhandbuch Seite 199

9.7 Fitting the appliance
Mounting the air duct connection
Before inserting the hob into the worktop cut-out,
the extractor connection box and the bend pipe must be fitted,
as follows:
• If necessary, saw the extractor connection box
to the correct size so that the pipe runs at a min. distance
of 5 mm from the inner wall of the built-in furniture
after inserting the hob.
The following sketch can help you to determine the dimensions:
B = min. 5mm
490 mm
R
F Front
R Rear
A
F R
X
X = B + A
Mounting and Installation
490 mm
F
95