Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Inserting the active charcoal filter for recirculation mode
For recirculation operation, the 2-part active charcoal
filter including the flap above it is required.
To insert this, proceed as follows:
• First remove the protective film from each
new filter element (1).
• Insert the two charcoal filter components
into the opening (2).
Pay particular attention to the direction
of the arrows on the top
of each of them (2.1).
• Now insert the cover flap into the opening
in a vertical position (3).
• Position it accordingly
and then fold them down sideways (4).
Make sure that the smooth, labelled side
is facing upwards (4.1).
• Press the flap down
so that it clicks into place (5).
Note:
If this is not possible,
check that both components
of the active charcoal filter
are fully inserted
and correct their position
if necessary. (5.1).
4.1
Mounting and Installation
2.1
5.1
1
2
3
4
5
93
Werbung
