Inhaltsverzeichnis
Werbung
...
General
Status Code
0x11
0x12
0x13
0x14
0x15
0x16
0x17
0x18
0x19
0x1A
0x1B
0x1C
0x1D
0x1E
0x1F
0x20
0x21
...
Printed in the Federal Republic of Germany
01/27/2022
Name
Description
Reply data too
The data to be transmitted in the response buffer
large
is larger than the allocated response buffer.
The service specified an operation that is going to
Fragmentation of a
fragment a primitive data value, i.e. half a REAL
primitive value
data type.
The service did not supply enough data to
Not enough data
perform the specified operation.
Attribute not
The attribute specified in the request is not
supported
supported.
The service supplied more data than was
Too much data
expected.
Object does not
The object specified does not exist in the device.
exist
Service
fragmentation
The fragmentation sequence for this service is not
sequence not in
currently active for this data.
progress
No stored attribute
The attribute data of this object was not saved
data
prior to the requested service.
Store operation
The attribute data of this object was not saved
failure
due to a failure during the attempt.
The service request packet was too large for
Routing failure,
transmission on a network in the path to the
request packet too
destination. The routing device was forced to
large
abort the service.
The service response packet was too large for
Routing failure,
transmission on a network in the path from the
response packet
destination. The routing device was forced to
too large
abort the service.
The service did not supply an attribute in a list of
Missing attribute
attributes that was needed by the service to
list entry data
perform the requested behavior.
The service is returning the list of attributes
Invalid attribute
supplied with status information for those
value list
attributes that were invalid.
Embedded service
An embedded service resulted in an error.
error
Vendor specific
-
error
A parameter associated with the request was
invalid. This code is used when a parameter does
Invalid parameter
not meet the requirements of the ODVA™
specification and/or the requirements defined in
an Application Object Specification.
An attempt was made to write to a write-once
Write-once value or
medium (e.g. WORM drive, PROM) that has
medium already
already been written, or to modify a value that
written
cannot be changed once established.
TR-ECE-BA-DGB-0102 v10
TR-Electronic GmbH 2013, All Rights Reserved
Page 173 of 175
Werbung
Inhaltsverzeichnis
