Drive Shaft; Limit Switch - Rk Rose+Krieger Rk Monoline R Montageanleitung

Set-up and function
Optional modules > Limit switch

3.3.3 Drive shaft

Fig. 8: Drive shaft
A Drive shaft (size 40)
B Drive shaft (size 60)

3.3.4 Limit switch

92
The drive shaft is assembled on the pulley box and transmits tor-
ques from the motor to the linear unit.
Unlike the other sizes, the drive shaft in size 60 is
not equipped with an adapter washer.
Further information:
n Assembling the drive shaft
Fig. 9: Limit switch
A Mechanical limit switch
B Inductive limit switch
The limit switch is assembled on the side of the guide profile above
holding plates/mounting brackets and stops the guide carriage
from exceeding the defined end positions.
Further information:
Assembling limit switches
n
Linear unit RK MonoLine R/RK MonoLine Z
C Drive shaft (size 80)
D Drive shaft (size 120)
Ä Page 105
Ä Page 107
14.10.2021