Ottobock Skippi Gebrauchsanweisung Seite 124

Transportation and Storage
Fig. 14 Loosen the height-adjustable push handles
To reduce the required space, the two battery packs can be
placed back into the drive unit. Ensure that the red arrows
on the battery packs point forward. The locking lever should
be engaged again to prevent the battery packs from falling
out.
The control panel can be laid on top of the battery packs
(Fig. 12) or placed into the corresponding holder. Ensure
that the control panel is not switched on and that cables are
not pinched.
Now the power wheelchair is ready to transport and can be
stowed in a vehicle.
124 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
NOTICE
Risk of damage if not tied down sufficiently. Secure the
disassembled parts of the power wheelchair properly so
that they cannot slide.
Perform the steps listed above in reverse order to reassem-
ble the Skippi power wheelchair.
Ensure that the locking bar is pushed back into its proper
position (see Fig. 14a, Pos. 1) and both locking pins engage
correctly (see Fig. 14a, Pos. 2).
CAUTION
Risk of injury if the locking mechanism is not properly
engaged.
Check that the locking pins are properly engaged at both
sides on the outside of the base support. The bolts must be
clearly visible so that the frame cannot unexpectedly disen-
gage from the drive unit sustainer. (see Fig. 11a, Pos. 3).
Skippi