Batteries - Ottobock Skippi Gebrauchsanweisung

INFORMATION
If the control unit does not indicate an error on the control
panel when the wheel lock lever is disengaged, this indi-
cates a malfunction which must be corrected by the spe-
cialist dealer promptly.
INFORMATION
All braking systems are deactivated once the wheel lock
release lever has been disengaged.
INFORMATION
The control unit may be switched off in push mode.
Engaging/activating the wheel lock
To engage the wheel lock, push the red wheel lock release
lever (Fig. 32) back until the safety pin clicks into place.
The control unit activates the driving function again when
both wheel lock release levers are engaged.
Skippi
Downloaded from www.Manualslib.com manuals search engine
6.5

Batteries

NOTICE
Risk of damage to the battery packs. The batteries are
encapsulated in battery packs at the factory. The battery
packs may not be opened, since this could cause irrevers-
ible damage to the encapsulated batteries or the battery
pack.
INFORMATION
Checking the remaining battery capacity and charging the
battery in time are essential in order to ensure the opera-
tional safety of your power wheelchair.
INFORMATION
Before doing any maintenance work on the batteries,
please read the battery manufacturer's warnings thor-
oughly. Observe the disposal information (see chapter 11).
The Skippi power wheelchair is equipped, at the factory, with
two maintenance-free gel batteries with a capacity of 31 Ah
(C20). The batteries are located in 2 battery packs below
the seat of the power wheelchair (Fig. 33).
To display the battery capacity on the control panel, see
chapter 6.3.4.
Operation
Ottobock 145
|