Control Panel; Adapting The Armrest To The Upper Arm Length; Adapting The Armrests To The Forearm Length - Ottobock Skippi Gebrauchsanweisung

Fig. 18

Adapting the armrest to the upper arm length

Adapting the armrests to the forearm length

1. Use a size 3 Allen wrench to loosen both set screws on
the bottom of the armrest. Three set screws need to be
loosened on the side where the control panel is mounted.
2. Move the armrest with the control panel holder or re-
placement tube forward or backwards along the attach-
ment rail to the desired position.
3. Retighten all set screws.
Skippi
Downloaded from www.Manualslib.com manuals search engine
Fig. 19 Adapting the armrests to the forearm length

6.1.4 Control Panel

CAUTION
Risk of accidents and injury due to uncontrolled move-
ments of the wheelchair. Turn the power wheelchair con-
trol unit off before mounting or removing the control panel
or changing its position.
NOTICE
Cable damage. Positioning the cable incorrectly can lead to
pinching and thus damage to the cable. The cable must not
be too tight or too loose. Avoid bending or crushing the cable.
Operation
Ottobock 129
|