Ottobock Skippi Gebrauchsanweisung Seite 108

Safety
NOTICE
Damage due to improper use of the electric seat ad-
justment. The power wheelchair can be equipped with
seat height, back angle, and/or seat tilt adjustment fea-
tures. The following particularities must be observed dur-
ing operation:
„ The seat function actuators are not intended for con-
tinuous use, only for short-term operation under limited
loads (10 % use, 90 % idle time). As a guideline, 10
seconds of activation time under maximum load should
be followed by approx. 90 seconds of idle time. The
electric seat functions are considered independent of
the driving function for this purpose.
„ Overloading the actuators may cause the spindle nut to
break, causing the seat to sag or the backrest to flip
back. Observe the activation time guidelines specified
above.
„ A maximum load of 50 kg may be applied to the seat
with seat height adjustment function.
„ The electric seat function may not be activated in case
of faults or malfunction.
108 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
„ If creep speed is not activated when the seat height
adjustment function is used, please visit a specialist
dealer immediately. The power wheelchair may only be
used with the seat height adjustment in its lowest posi-
tion until the fault is repaired.
NOTICE
Risk of tyre damage. Excessively high pressure may dam-
age the tyres. Observe the specifications in the "Technical
Data" chapter. The specified tyre air pressure may not be
exceeded.
NOTICE
Risk of damage due to excessive heat or cold. The
power wheelchair may only be operated in the temperature
range from -25 °C to +50 °C. It must not be operated at
temperatures outside this range.
NOTICE
Damage due to overloading. The maximum load capacity
for the power wheelchair is 50 kg. This load capacity must
not be exceeded.
Skippi