Ottobock Skippi Gebrauchsanweisung Seite 154

Accessories
WARNING
Risk of falling caused by overload. Note that the maxi-
mum permitted load of the power wheelchair may be redu-
ced when using the options „Electric seat height adjust-
ment" and „Electric seat tilt" (see „Technical Data" sec-
tion).
WARNING
Risk of pinching or crushing in the electric seat adjust-
ment area.
„ Note that when electric seat options are used, inherent
pinch and shear points are located between the seat
frame and the power wheelchair frame.
„ Ensure that no body parts, such as hands or feet, are in
the danger area while electric seat options are used.
„ Ensure that no interfering objects, such as clothing or
other obstacles, are in the danger area while electric
seat options are used.
WARNING
Risk of pinching or crushing when actuators are over-
loaded. Avoid overloading the actuators. Overloading may
cause the spindle nut to break, causing the seat to sag or
the backrest to flip back suddenly.
154 | Ottobock
Downloaded from www.Manualslib.com manuals search engine
NOTICE
Damage due to improper use of the electric seat op-
tions.
„ When using electric seat options, note that the seat
function actuators are not designed for continuous use,
only for short-term use under limited loads (10% load,
90% idle time).
„ Observe the following guidelines: at maximum load ca-
pacity, 10 seconds of activation time must be followed
by approx. 90 seconds of idle time. The electric seat
functions are considered independently of the driving
function for this purpose.
„ Only activate the electric seat functions if no fault or
error is present.
INFORMATION
Bring the seat to a level position when getting into or out of
the power wheelchair.
INFORMATION
For safe operation, please also observe the information in
chapter 2.3 "General Safety Instructions" and chapter 2.5
"Safety Requirements for Operation".
Skippi